WPS
This page allows you to change the setting for WPS (Wi-Fi
Protected Setup). Using this feature could let your wireless
client automatically synchronize its setting and connect to the
Access Point in a minute without any hassle. To access the
Wireless NetworkWPSpage:
1. From the head menu, click on WAN1.
2. From the left-hand menu, click on WPS. The following page
is displayed:
Checking this box and clicking “Save & Apply” will disable Wi-Fi
Protected Setup. WPS is turned on by default.
When AP’s settings are factory default (out of box), it is set to open
security and un-configured state. It will be displayed by “WPS
Status”. If it already shows “Configured”, some registrars such as
Vista WCN will not configure AP. Users will need to go to the
“Save/Reload Settings” page and click “Reset” to reload factory
default settings.
“Self-PIN Number” is AP’s PIN. Whenever users want to change
AP’s PIN, they could click “Regenerate PIN” and then click “ Save &
Apply”. Moreover, if users want to make their own PIN, they could
enter four digit PIN without checksum and then click “ Save &
Apply”. However, this would not be recommended since the
registrar side needs to be supported with four digit PIN.
To Next Page
Loading...
