LevelOne WBR-6013 - WEP + Use 802.1 X Authentication

75
9. Change setting successfully! Do not turn off or reboot the
Device during this time. Please wait 20 seconds ...
WEP + Use 802.1x Authentication
WEP aims to provide security by encrypting data over radio
waves so that it is protected as it is transmitted from one end
point to another. However, it has been found that WEP is not as
secure as once believed.
1. From the Encryption drop-down list, select WEP setting.
2. Check the option of Use 802.1x Authentication.
3. Click on the ratio of WEP 64bits or WEP 128bits.
4. Enter the Port, IP Address andPassword of RADIUS Server:
5. Click Save & Apply button.
6. Click OK button.