LevelOne WBR-6013 - Page 62

62
To configure security, choose one of the following options:
 If you do not want to use Wireless Network security, From
the Encryption drop-down list, select None setting and then
click Finished.None is the default setting, but you are
strongly recommended to use wireless network security
on your device.
 If you want to use WEP 64bit ASCII (5 characters) data
encryption, follow the instructions in Configuring 64bit ASCII
(5 characters) encryption.
 If you want to use WEP 64bit Hex (10 characters) data
encryption, follow the instructions in Configuring WEP64bit
Hex (10 characters)security.
 If you want to use WEP 128bit ASCII (5 characters) data
encryption, follow the instructions in Configuring WEP
128bit ASCII (5 characters)security.
 If you want to use WEP 128bit Hex (10 characters) data
encryption, follow the instructions in Configuring WEP
128bit Hex (10 characters)security.
 If you want to use WPA2(AES) - Wi-Fi Protected Access
2(AES) Passphrase encryption, follow the instructions in
Configuring WPA2 (AES) Passphrase security.
 If you want to use WPA2 (AES) - Wi-Fi Protected Access
2(AES) HEX (64 characters) encryption, follow the
instructions in Configuring WPA2 (AES) HEX (64
characters) security.
 If you want to use WPA Mixed- Wi-Fi Protected Access
2(Mixed) Passphrase encryption, follow the instructions in
Configuring WPA2 (Mixed) Passphrase security.
 If you want to use WPA Mixed- Wi-Fi Protected Access
2(Mixed) HEX (64 characters) encryption, follow the
instructions in Configuring WPA2 (Mixed) HEX (64
characters) security.