Lexmark C510 - Page 182

Understanding printer messages
182
Understanding printer messages
39 Complex Page The page may not print correctly
because the print information on the
page is too complex.
• Press Go to clear the message and
continue printing the job. The job may
not print correctly.
• Press Menu to open the Job Menu
and cancel the current job.
• To avoid this error in the future:
– Reduce the complexity of the page
by reducing the amount of text or
graphics on the page and deleting
unnecessary downloaded fonts or
macros.
– Set Page Protect to On in the Setup
Menu.
– Install additional printer memory.
See also: Setup Menu
4<x> Unsupported
Firmware Card
The printer detects an unsupported
version of firmware on the installed
firmware card.
• Turn the printer off, and then press
and hold Go while turning it on. The
printer reads the code on the system
card and bypasses the code on the
firmware card.
• Remove the firmware card.
See also: Setup Guide
51 Defective Flash The printer detects defective flash
memory.
Press Go to clear the message and
continue printing. You must install
different flash memory before you can
download any resources to flash.
52 Flash Full There is not enough free space in
the flash memory to store the data
you are trying to download.
• Press Go to clear the message and
continue printing. Downloaded fonts
and macros not previously stored in
flash memory are deleted.
• Delete fonts, macros, and other data
stored on the flash memory.
• Install flash memory with more
storage capacity.
53 Unformatted Flash The printer detects unformatted
flash memory.
• Press Go to clear the message and
continue printing. You must format the
flash memory before you can store
any resources on it.
• If the error message remains, the
flash memory may be defective and
require replacing.
54 Serial Option <x>
Error
The printer has detected a serial
interface error on a serial port.
• Make sure the serial link is set up
correctly and you are using the
appropriate cable.
• Press Go to clear the message and
continue printing. The job may not
print correctly.
• Press Menu to open the Job Menu
and reset the printer.
54 Standard Serial
Error
Message What this message means What you can do