Lexmark C510 - Page 183

Understanding printer messages
183
Understanding printer messages
54 Network <x>
Software Error
The printer cannot establish
communications with an installed
network port.
• Press Go to clear the message and
continue printing. The job may not
print correctly.
• Program new firmware for the network
interface by way of the parallel port.
• Press Menu to open the Job Menu
and reset the printer.
54 Std Network
Software Error
54 Std Par ENA
Connection Lost
The printer has lost the connection
to an external print server (also
called an external network adapter
or ENA).
• Make sure the cable connecting the
ENA and the printer is securely
attached. Turn the printer off and then
on to reset the printer.
• Press Go to clear the message. The
printer erases any reference to the
ENA and then resets.
54 Par <x> ENA
Connection Lost
55 Unsupported Option
in Slot <x>
An unsupported option card is
installed in one of the ports or an
unsupported flash DIMM is installed
in a memory slot.
Turn off and unplug the printer. Remove
the unsupported option. Plug in the
printer and turn it on.
See Removing optional cards for help.
55 Unsupported Flash
in Slot <x>
56 Serial Port <x>
Disabled
Data has been sent to the printer
through a serial port, but the serial
port is disabled.
• Press Go to clear the message. The
printer discards any data received
through the serial port.
• Make sure the Serial Buffer menu
item in the Serial Menu is not set to
Disabled.
See also: Serial Buffer
56 Parallel Port <x>
Disabled
Data has been sent to the printer
through a parallel port, but the
parallel port is disabled.
• Press Go to clear the message. The
printer discards any data received
through the parallel port.
• Make sure the Parallel Buffer menu
item in the Parallel Menu is not set to
Disabled.
See also: Parallel Buffer
56 Std Parallel Port
Disabled
56 USB Port <x>
Disabled
Data has been sent to the printer
through a USB port, but the USB
port is disabled.
• Press Go to clear the message. The
printer discards any data received
through the USB port.
• Make sure the USB Buffer menu item
in the USB Menu is not set to
Disabled.
See also: USB Buffer
56 Standard USB Port
Disabled
57 Configuration
Change
The printer cannot restore
confidential or held jobs on the hard
disk because the print configuration
has changed.
Note: The messages 57
Configuration Change and Held
Jobs May Not Be Restored
alternate on the display.
Press Go to clear the message.
Message What this message means What you can do