2-8 Lexmark™ E360d, E360dn
4513-420, -430
Prog System Code
DO NOT POWER OFF
The printer is programming new system code. Wait for the message to
clear and the printer to reset.
Warning: Do not turn the printer off while this message is displayed.
Ready Send a job to print.
Remove Paper Standard Bin The standard output bin is full.
Resetting Maint Cnt Valu The printer is resetting the counter that tracks wear on the fuser.
Resetting PC Cnt Value The printer is resetting the counter that tracks wear on the photoconductor.
Resetting the Printer Wait for the message to clear.
Res Reduced The printer is reducing the resolution of a page in the current job from 600
dots per inch (dpi) to 300 dpi to prevent a 38 Memory Full error. Res
Reduced remains on the display while the job prints.
Restoring Factory Defaults Wait for the message to clear.
Note: When factory default settings are restored:
• All downloaded resources (fonts, macros, symbol sets) in the
printer memory are deleted.
• All menu settings return to the factory default except:
– The Display Language setting in the Setup Menu
– All settings in the Parallel Menu, Network Menu, and
USB Menu
Std Bin Full The standard bin is full.
Toner Low • Replace the toner cartridge.
• Press to clear the message and continue printing.
Tray <x> Missing Insert the tray into the printer.
USM The printer is processing data through the specified USB port.
Waiting The printer has received a page of data to print, but is waiting for an End of
Job command, a Form Feed command, or additional data.
• Press to print the contents of the buffer.
• Cancel the current job.
User attendance messages (Continued)
Message Action
To Next Page
Loading...
Need help?
General
Weight and Dimensions
