Check tray [x] connection
Try one or more of the following:
• Turn o the printer, and then turn it back on.
If the error occurs a second time, then:
1 Turn o the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the indicated tray.
4 Reattach the tray.
5 Connect the power cord to a properly grounded electrical outlet.
6 Turn the printer back on.
If the error occurs again, then:
1 Turn
o
the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the tray.
4 Contact customer support.
• From the printer control panel, touch Continue to clear the message and resume the job.
Close front door
Close the front door of the printer.
Close
flatbed
cover and load originals if restarting job [2yy.xx]
Try one or more of the following:
• Tou ch Scan from automatic feeder to continue scanning from the ADF immediately after the last
successful scan job.
• Tou ch Scan from flatbed to continue scanning from the scanner glass immediately after the last
successful scan job.
• Tou ch Finish job without further scanning to end the last successful scan job.
Note: This does not cancel the scan job. All successfully scanned pages will be processed further
for copying, faxing, or e-mailing.
• Tou ch Cancel job to clear the message and cancel the scan job.
Complex page, some data may not have printed [39]
Try one or more of the following:
• From the printer control panel, touch Continue to ignore the message and continue printing.
• Cancel current print job.
• Install additional printer memory.
7016
Diagnostic information
110
To Next Page
Loading...
