Lexmark MX61 SERIES - Configuration Change, some Held Jobs Were Not Restored [57]; Defective Flash Detected [51]; Disk Full [62]; Disk Must be Formatted for Use in this Device

Configuration change, some held jobs were not restored [57]
Held jobs are invalidated because of the following possible changes in the printer:
• The printer firmware has been updated.
• The tray for the print job has been removed.
• The print job is sent from a flash drive that is no longer attached to the USB port.
• The printer hard disk contains print jobs that were stored when the hard disk was installed in a dierent
printer model.
From the printer control panel, touch Continue to clear the message.
Defective
flash
detected [51]
Try one or more of the following:
• Replace the defective flash memory card.
• From the printer control panel, touch Continue to ignore the message and continue printing.
• Cancel the current print job.
Disk full [62]
Try one or more of the following:
• From the printer control panel, touch Continue to clear the message and continue processing.
• Delete fonts, macros, and other data stored in the printer hard disk.
• Install a printer hard disk with larger capacity.
Disk must be formatted for use in this device
From the printer control panel, touch Format disk to format the printer hard disk and clear the message.
Note: Formatting deletes all the files stored in the printer hard disk.
Disk near full. Securely clearing disk space.
Try one or more of the following:
• Tou ch Continue to clear the message and continue printing.
• Delete fonts, macros, and other data stored on the printer hard disk.
• Install a hard disk with higher capacity.
Error reading USB drive. Remove USB.
An unsupported USB device is inserted. Remove the USB device, and then insert a supported one.
Error reading USB hub. Remove hub.
An unsupported USB hub has been inserted. Remove the USB hub, and then install a supported one.
7016
Diagnostic information
111