3 Remove the two screws (A), and then remove the fan.
Controller board removal
Note: Back up the eSF solutions and settings before replacing the controller board. For more information,
see
“Backing up eSF solutions and settings” on page 246.
1 Remove the right cover. See “Right cover removal” on page 277.
2 Remove the controller board shield. See “Controller board shield removal” on page 284.
3 Disconnect all internal options attached to the board (memory card, internal solutions port, hard disk).
4 Disconnect all cables from the controller board.
7016
Repair information
282
To Next Page
Loading...
