Installation note: After the new controller board is installed, perform scanner manual registration (see
“Scanner manual registration” on page 227), printhead registration (see “Printhead assembly
adjustments” on page 261) and printer configuration restoration (see “Restoring the printer configuration
after replacing the controller board” on page 241).
Controller board shield removal
1 Remove the right cover. See “Right cover removal” on page 277.
2 Remove the optional hard disk, if present.
3 Loosen the two screws (A) securing the shield to the front of the printer frame.
7016
Repair information
284
To Next Page
Loading...
