Bin full service check
Action Yes No
Step 1
Update the firmware.
Note: Contact the next level of support for the correct firmware
level.
Does the problem remain?
Go to step 2. The problem is
solved.
Step 2
Check the bin full sensor cables for continuity.
Is there continuity?
Go to step 3. Replace the bin full
sensor cable. See
“Bin full sensor
cable removal” on
page 354.
If the problem
remains, then go to
step 3.
Step 3
Replace the bin full sensor. See
“Bin full sensor/lens removal” on
page 352.
Does the problem remain?
Go to step 4. The problem is
solved.
Step 4
Replace the controller board. See
“Controller board removal” on
page 282.
Does the problem remain?
Contact the next
level of support.
The problem is
solved.
7016
Diagnostic information
195
To Next Page
Loading...
