Lexmark MX61 SERIES - Stapler Accumulator Assembly Removal; Sensor (Stapler Right Tamper HP) Removal

Stapler accumulator assembly removal
1 Remove the stapler right cover. See “Stapler right cover removal” on page 384.
2 Remove the stapler left cover. See “Stapler left cover removal” on page 385.
3 Remove the stapler rear cover. See “Stapler rear cover removal” on page 393.
4 Remove the stapler rear door. See “Stapler rear door removal” on page 386.
5 Remove the stapler service cover. See “Stapler service cover removal” on page 397.
6 Remove the stapler controller card. See “Stapler controller card removal” on page 397.
7 Remove the stapler cooling fan. See “Stapler cooling fan removal” on page 401.
8 Remove the stapler power supply unit. See “Stapler power supply unit removal” on page 401.
9 Remove the stapler top cover. See “Stapler top cover removal” on page 405.
10 Remove the tamper main assembly. See “Tamper main assembly removal” on page 415.
The accumulator assembly remains.
Sensor (stapler right tamper HP) removal
1 Remove the stapler right cover. See “Stapler right cover removal” on page 384.
2 Remove the stapler left cover. See “Stapler left cover removal” on page 385.
3 Remove the stapler rear cover. See “Stapler rear cover removal” on page 393.
4 Remove the stapler service cover. See “Stapler service cover removal” on page 397.
5 Remove the stapler controller card. See “Stapler controller card removal” on page 397.
6 Remove the stapler cooling fan. See “Stapler cooling fan removal” on page 401.
7 Remove the stapler power supply unit. See “Stapler power supply unit removal” on page 401.
8 Remove the stapler top cover. See “Stapler top cover removal” on page 405.
9 Remove the tamper main assembly. See “Tamper main assembly removal” on page 415.
10 Remove the tamper sub-assembly. See “Tamper sub-assembly removal” on page 416.
7016
Repair information
422