5 Close the finisher rear door.
6 If necessary, touch Done from the printer control panel to clear the message and continue printing.
200 paper jams
200 paper jam messages
Notes:
• Some error messages are applicable only to printer models with installed polygon LSU (laser scanning
unit).
• If the sixth digit character assigned to the serial number of the printer is in the P–Z range, then the
printer is installed with a polygon LSU (example: 4514 2ZHH 007CR).
Error code Description Action
200.01 Input sensor covered during warm-up sequence. Go to
“Sensor (input) static jam service check”
on page 75.
200.02 Input sensor covered too quickly. Go to
“Sensor (input) early/late arriving service
check” on page 76.
200.03 Media did not reach input sensor from MPF. Go to
“Sensor (input) early/late arriving service
check” on page 76.
200.05 Input sensor covered too long. Go to
“Sensor (input) early/late arriving service
check” on page 76.
200.07 Input sensor failed to become uncovered from
sheet ahead.
Go to
“Sensor (input) early/late arriving service
check” on page 76.
200.08 Page arrive at input senor at unexpected time. Go to
“Sensor (input) early/late arriving service
check” on page 76.
200.09 Printhead did not receive proper motor feedback
to start laser servo.
Go to
“Sensor (input) image jam service check”
on page 77.
200.10 Printhead motor not locked when media reaches
the input sensor.
Go to
“Sensor (input) image jam service check”
on page 77.
7016
Diagnostic information
73
To Next Page
Loading...
