Lexmark MX61 SERIES - Some Held Jobs Were Not Restored; Standard Network Software Error [54]; Standard USB Port Disabled [56]; Supply Needed to Complete Job

Some held jobs were not restored
From the printer control panel, touch Continue to delete the indicated job.
Note: Held jobs that are not restored remain in the printer hard disk and are inaccessible.
Standard network software error [54]
Try one or more of the following:
• From the printer control panel, touch Continue to continue printing.
• Turn o the printer, and then turn it back on.
• Update the network firmware in the printer or print server. For more information, contact customer
support.
Standard USB port disabled [56]
Try one or more of the following:
• From the printer control panel, touch Continue to clear the message.
• Enable the USB port. From the printer control panel, navigate to:
Network/Ports > USB
Buer
> Auto
Note: The printer discards any data received through the USB port.
Supply needed to complete job
Do either of the following:
• Install the missing supply to complete the job.
• Cancel the current job.
Too many flash options installed [58]
1 Turn o the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the extra
flash
memory.
4 Connect the power cord to a properly grounded electrical outlet.
5 Turn the printer back on.
Too many trays attached [58]
1 Turn
o
the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the extra trays.
7016
Diagnostic information
121