Clear Log
Use this to remove all the current information in the Event log. This
aects
both the viewed log and the printed
log information.
To clear the event log:
1 From the Diagnostics menu, navigate to:
Event Log > Clear Log
2 Choose any of the following:
• Yes—To clear the Event log
• No—To exit the Clear log menu
Scanner tests
• “ASIC Test” on page 218
• “Motor tests” on page 218
• “Feed test” on page 219
• “Sensor tests” on page 219
• “Scanner calibration reset” on page 222
• “ADF magnification” on page 222
ASIC Test
This setting initiates a scan of the scanner ASIC’s memory.
To perform this test, do the following:
1 Navigate to Scanner Tests > ASIC Test.
2 The test executes. While this test executes, the screen displays ASIC Test Running.... If the scanner
ASIC passed the test, then the panel posts ASIC Test Passed. Rebooting.... If the scanner ASIC
failed the test, then the panel posts ASIC Test Failed. Rebooting....
Motor tests
ADF pick
When Motor On is selected, the device runs the pick motor continuously for
five
seconds and then automatically
stops the motor.
To perform this test, do the following:
1 Navigate to Scanner Tests > Motor Tests.
2 Select ADF pick.
The test will run if it is working properly.
Flatbed scanner motor
When Motor On is selected, the device moves the flatbed scanner along the entire flatbed scanner path (that
is, to the far wall and back to the Home position) and then automatically stops at the Home position.
7016
Service menus
218
To Next Page
Loading...
