Bottom side removals
Power supply removal
1 Remove the left cover. See “Left cover removal” on page 264.
2 Remove the rear door and cover. See “Rear exit door removal” on page 342 and “Rear cover removal”
on page 343.
3 Disconnect the fuser cable from the power supply, and disconnect the transfer roll cable from the left side
of the printer.
4 Position the printer so that it sits on its right side.
5 Remove the five metal screws (A) and the plastic screw (B) securing the power supply.
6 Remove the power supply, and then disconnect the cable from the power supply.
Power supply shield removal
1 Remove the left cover. See “Left cover removal” on page 264.
2 Remove the rear door and cover. See “Rear exit door removal” on page 342 and “Rear cover removal”
on page 343.
3 Remove the power supply. See “Power supply removal” on page 323.
4 Position the printer so that it sits on its right side.
7016
Repair information
323
To Next Page
Loading...
