Action Yes No
Step 3
a Turn o the printer.
b Remove the power cord.
c Measure the resistance between terminals A and D of the
power supply socket.
Is the resistance approximately 30 ohms?
Contact your next
level of support.
Replace the LVPS.
See
“Power supply
removal” on
page 323.
132 errors
132 error messages
Error code Description Action
132.01 TDS baseline too low. Go to
“Toner density sensor service check” on
page 138.
132.02 TDS baseline too high.
132.03 TDS baseline excessive range.
132.16 TDS calibration at maximum.
132.17 TDS calibration too low.
132.18 TDS calibration too close to baseline.
132.32 PC drum measurement too high.
132.33 PC drum measurement too dierent from
calibration.
132.34 PC drum measurement too close to baseline.
Toner density sensor service check
Action Yes No
Step 1
Remove the transfer roll, and then check for loose toner blocking
the toner density sensor.
Is it free of loose toner?
Go to step 2. Clean the sensor.
Step 2
Check the TDS for proper operation:
a Lower the ACM assembly.
b Move the toner density sensor wiper from left to right.
Does it move freely?
Go to step 3. Reinstall the wiper
properly. If it still
cannot move freely,
then replace the
toner density sensor.
See
“Toner density
sensor removal” on
page 330.
7016
Diagnostic information
138
To Next Page
Loading...
