Lexmark MX61 SERIES - Skewed Print Check

Actions Yes No
Step 5
a Turn o the printer.
b Remove the rear door and cover.
c Disconnect the fuser cable connected to PCN5 of the power
supply.
d Check for approximate correct resistance on the fuser cable:
• 220 V fuser—43 ohms
• 110 V fuser—10 ohms
• 100 V fuser—8 ohms
Is the resistance equal to any of the above values?
The problem is
solved.
Replace the fuser.
See
“Fuser
removal” on
page 346.
Skewed print check
) )
ABCDE
ABCDE
ABCDE
Actions Yes No
Step 1
a POR into the Diagnostics menu and perform a print test:
Diagnostics Menu > Print Tests > Tray 1
b Adjust the margins if necessary:
Diagnostics Menu > Registration
Does the error remain?
Go to step 2. The problem is
solved.
Step 2
Does the skew appear every two pages?
Go to step 9. Go to step 3.
Step 3
Check the media source.
Is the media from Tray 1?
Go to step 4. If the media is from
the MPF, then go to
step 6.
Step 4
Make sure the pick tires are free of debris. Check for wear or
damage.
Are they free of wear or damage?
Go to step 5. Replace the pick
tires.
7016
Diagnostic information
48