Lexmark MX61 SERIES - Page 25

April 12, 2016
• Updated the Electronics 1 assembly to add bin full sensor with PN 40X9119.
March 23, 2016
• Revised the topic “Fuser removal” in the “Rear side removals" group of the “Repair information” chapter.
• Revised the topic “Right cover removal” in the “Right side removals" group of the “Repair information”
chapter.
• Revised the topic “Covers” in the ”Parts catalog” chapter.
• Revised the following topics in the “Diagnostic information” chapter:
– Performing the initial troubleshooting check
– Initial print quality check
– User attendance messages (0‑99.99)
– Toner cartridge smart chip contact service check
– Imaging unit smart chip contact service check
– Toner smart chip compatibility service check
– Imaging chip compatibility service check
– Printer/cartridge mismatch service check
– Toner starvation service check
• Created these new checks:
– Unsupported imaging unit service check
– Unresponsive toner cartridge service check
– Printer cartridge mismatch
– Unsupported toner cartridge
– Supplies mismatch service check
• Updated CTLS service check. Even changed the title to “Unresponsive imaging unit service check.”
February 18, 2016
• Added the topic “Enabling the security reset jumper” in ”Appendix A: Printer specifications” chapter.
January 10, 2016
• Removed 41X0003 from the topic “Electronics 2” in the “Parts catalog” chapter.
December 15, 2015
• Updated the topic “Fuser removal” of the ”Rear side” group of the “Repair information” chapter to add
installation notes.
December 1, 2015
• Updated the topic “Toner density sensor removal” in the ”Bottom removals” group in the “Repair information”
chapter to add installation notes.
• Updated the topic “Frame” in the “Parts catalog” chapter to update 40X8278 to 40X8777.
November 17, 2015
• Change PN 40X8047 to 40X8045.
7016
Preface
25