126
34
Replacing pick rollers
The pick rollers come in a package of 15 in the maintenance kit. Replace three in each tray when the
printer issues the 80 Scheduled Maintenance message. If you don’t have a high capacity feeder,
you will have nine pick rollers left over from the package.
A pick roller transports the paper from an input tray to the paper path.
Removing old pick rollers
1 Remove trays 1 and 2 from the printer, and trays 3 and 4 from the optional high capacity input
feeder if it is installed. See the following topics to complete this step:
• Behind trays 1, 2, and 3
• Behind Tray 4
2 Set all trays aside.
3 Open tray 5 completely.
Note: The following illustrations show the process of removing old pick rollers; however,
the illustrations do not show all the trays removed. Focus on the removal of the pick
rollers. Ignore the trays still in the illustrations.
4 Start with the opening left by removing tray 1 and locate three pick rollers in the upper left
corner inside the printer.
5 Turn the bottom pick roller counterclockwise until you see the small tab on the end.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
