134
6 Slide the wiper blade foot on top of the angled alignment tab. Make sure the right side of the
blade is to the left of the vertical alignment tab.
7 Push the wiper blade in.
8 Make sure the pin on the finisher wall goes through the hole on bottom of the wiper blade.
Make sure the front of the wiper blade is flush with the wall behind it.
9 Hold the wiper blade firmly in place and tighten the screw.
10 Close the finisher door (Door K).
11 If you have already replaced all the items listed in the following note, you may turn the printer
on.
Note: Make sure you also follow the instructions in Replacing the fuser, Replacing the
transfer roller, Replacing pick rollers, and
Resetting the maintenance page counter.
Wiper blade foot
Angled
alignment
tab
Ver tical
alignment tab
Pin
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
