214
Staple Job
Purpose:
To set stapling as the default for all print jobs. (Select stapling from the printer driver if you want to
staple only specific jobs.)
Values:
See also:
Staple positions
Staple Prime Src
Purpose:
To specify the paper source you want the printer to use when it primes the stapler. When a staple
cartridge is replaced or a staple jam is cleared, the printer may need to prime the stapler by stapling a
sheet of paper several times.
Values:
Off* Does not staple print jobs.
Auto Automatically selects the best staple position for the print job based on the feed orientation.
See Staple position mapping for the Auto value.
Front Staples print jobs once according to paper size and feed orientation.
Back Staples print jobs once according to paper size and feed orientation.
Dual Staples two staples on the side of a print job.
Tray <x> (Tray 1*) Selects paper from the specified tray.
MP Feeder Selects paper from the multipurpose feeder.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
