43
• Do not overload the print media sources. Make sure the stack height does not exceed the
maximum height indicated by the labels in the sources.
• Push all trays
firmly
into the printer after loading them.
• Make sure the guides in the trays are properly positioned for the size print media you have
loaded.
• Do not load print media in a tray while a job is printing by selecting print media from this same
tray. Wait for a Load Tray <x> message before you remove the tray from the printer. After
you reinstall the loaded tray, press
Go to continue printing. You may remove another tray and
load it so long as the print job is not selecting the print media from it.
• Do not send jobs to staple, hole punch, or offset for transparencies, labels, or card stock.
• We recommend that transparencies, labels, card stock, and envelopes not be sent to the
optional mailbox or optional finisher. These print media types should be sent to the standard
bin.
• If an optional finisher or mailbox is attached to your printer, make sure the printer and option
are correctly aligned. Refer to the
Setup Guide
for alignment instructions.
• Make sure all cables that connect the duplex unit, high capacity feeder, finisher, or mailbox to
the printer are correctly attached. Refer to the
Setup Guide
for more information.
• If a jam should occur, check the operator panel message to locate the correct jam access
doors. See Message maps for more information.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
