135
3-2. Opening, closing and locking the doors
3
Operation of each component
RX350_U_OM48E90U
■ Power back door operating conditions
If the following conditions are met with the power back door operation enabled (P. 100),
the power back door can be opened and closed automatically.
● When an electronic key is being carried and the back door opener switch is pressed*
● When the wireless remote control is used*
● When the engine switch is in IGNITION ON mode, the vehicle speed must be lower
than 2 mph (3 km/h) and one of the following conditions must be met in addition to the
above conditions:
• The parking brake is engaged.
• The brake pedal is depressed.
• The shift lever is in P.
*: When the operation of the power back door when it is locked has been disabled by a
customized setting, operate the power back door after it has been unlocked.
(P. 704)
Touchless sensor (vehicles with a touchless power back door)
The power back door will open automatically when the touchless sensor operation is
enabled (P. 100) and the following conditions are met:
● The power back door is fully closed.
● The electronic key is within the operational range (P. 146)
■ Security feature
If the power back door is not opened within approximately 60 seconds after the vehicle
is unlocked, the security feature will automatically lock the doors again.
● A hand is held over the upper part of the rear
emblem with fingers closed. (The upper part of
the rear emblem can also be touched.)
The power back door may also be operated
by holding either of the following over the
upper part of the rear emblem. Make sure to
hold it close enough to the rear emblem.
•A gloved hand
•An elbow
To Next Page
Loading...
