164
3-3. Adjusting the seats
RX350_U_OM48E90U
■ Recall procedure
Check that the shift lever is in P.
Turn the engine switch to IGNITION ON mode.
Press one of the buttons for the
driving position you want to recall
until the buzzer sounds.
■ To stop the position recall operation part-way through
Perform any of the following:
● Press the “SET” button.
● Press button “1”, “2” or “3”.
● Operate any of the seat adjustment switches (only cancels seat position recall).
● Operate the tilt and telescopic steering control switch (only cancels steering wheel
position recall).
■ Seat positions that can be memorized (P. 1 52 )
The adjusted positions other than the position adjusted by lumbar support switch can be
recorded.
■ Operating the driving position memory after turning the engine switch off
Recorded seat positions can be activated up to 180 seconds after the driver’s door is
opened and another 60 seconds after it is closed again.
■ In order to correctly use the driving position memory function
If a seat position is already in the furthest possible position and the seat is operated in the
same direction, the recorded position may be slightly different when it is recalled.
1
2
To Next Page
Loading...
