138
3-2. Opening, closing and locking the doors
RX350_U_OM48E90U
■ Close & lock function
When the power back door is open, this function closes the power back door and then
locks all of the doors simultaneously.
Performing the following procedure will lock all of the doors when the power back door
is completely closed.
Close all of the doors except the power back door.
While carrying an electronic key, press the
switch on the lower part of the
power back door (P. 133) twice.
A different buzzer than the normal one will sound and then the power back door will
begin closing automatically. When the power back door is closed, all of the doors will
lock simultaneously and operation signals will indicate that all of the doors have been
locked.
To enable this function, the following conditions must be met:
● The most recent power back door operation was an automatic opening operation and
the power back door is stopped.
● No electronic keys for your vehicle are in the vehicle.
■ When reconnecting the battery
To enable the power back door to operate properly, close the power back door manually.
■ Jam protection function
■ Returning the power back door opening position to the default setting
Sensors are installed in the right and left sides of
the power back door. When the door is auto-
matically closing and the sensors are pushed
due to an object being caught, etc., the jam pro-
tection function will operate.
From that position the door will automatically
move a little in the opposite direction and then
the function will stop.
Press and hold the switch on the lower
part of the power back door for 7 seconds.
A buzzer will sound twice. The next time the
power back door is opened, it will open to the
default position.
1
2
To Next Page
Loading...
