LEYBOLD MAG Series User Manual

GA05141_0702 - 09/2004
71
Operation
3.5 Bakeout
Only for pumps with CF flange
If pressures in the range of 10
-8
mbar or below are to be developed, the
vacuum chamber and the components installed therein will have to be
baked out.
Protect the rotor against intensive, direct heat radiation. When baking out
at the forevacuum side – at a sorption trap, for example – ensure that the
components attached direct are not heated to more than 80 °C.
The forevacuum pump must be in operation so as to eliminate the vapors
liberated at the sorption trap.
The maximum bakeout temperature of the pump is 120 °C.

LEYBOLD MAG Series Specifications

General

Applications	Laboratory, medical, and industrial applications
Drive	Magnetic drive
Sealing	Hermetically sealed
Flow Rate	Varies depending on the model, ranging from a few liters per minute (LPM) to several tens of LPM. Consult specific model datasheets for precise values.
Max Pressure	Varies by model (typically up to 10 bar)
Power Supply	Typically available in various AC voltages (e.g., 115V, 230V) and frequencies (50/60 Hz)
Power Consumption	Varies depending on the model, ranging from a few watts to several hundred watts. Consult specific model datasheets for precise values.
Operating Temperature	Typically 0°C to +60°C
Weight	Varies depending on the model, ranging from a few kilograms to several kilograms. Consult specific model datasheets for precise values.
Dimensions	Varies depending on the model. Consult specific model datasheets for precise dimensions.
Materials	Stainless steel