GA05141_0702 - 09/2004
92
Maintenance
Support the pump with a lift-truck at the base plate and remove the 2
remaining bolts.
Clean the intake and forevacuum connection flange as necessary for good
adhesion of tape.
Place the dry cartridge into the forevacuum port. Don’t use loose crystals.
Firmly seal all ports with plastic adhesive film.
Cover the forevacuum connection port with its plastic cap.
Seal the high-vacuum connection flange with the cover and the screws.
Pack the pump so that it may not be damaged during transportation.
Particularly protect the flanges, the cooling water connectors and the cur-
rent feedthrough.
4.6 Service at Leybold’s
If you send a pump to Leybold indicate whether the pump is free of sub-
stances damaging to health or whether it is contaminated. If it is contami-
nated also indicate the nature of hazard. To do so, you must use a pre-
printed form which we shall send to you upon request.
A copy of this form is printed at the end of the Operating Instructions:
“Declaration of Contamination of Vacuum Equipment and Components”.
Another suitable form is available from the Leybold homepage:
http://www.leybold.com under the headline “customer service”.
Either fasten this form at the pump or simply enclose it to the pump.
Don’t pack the form with the pump into the PE bag.
This declaration of contamination is necessary to comply with legal requi-
rements and to protect our staff.
Leybold must return any pump without a declaration of contamination to
the sender’s address.
4.7 Disposal
The pump may be contaminated by the process or by environmental influ-
ences. In this case it must be decontaminated in accordance with the rele-
vant regulations. Leybold offers this service for fixed prices. Further details
are available on request.
Contaminated parts can be detrimental to health and environ-
ment. Before beginning to work, find out whether any parts are
contaminated. Adhere to the relevant regulations and take the
necessary precautions when handling contaminated parts.
Separate clean components according to their materials, and dispose of.
Leybold offers this service free of charge. Further details are available on
request.
If you send a pump to Leybold mind the regulations given in Section “4.6
Service at Leybold´s”.
Contamination
Seal all ports
Warning
Contamination
Form
To Next Page
Loading...
Need help?
General
