129
INSTALLER SETTING
ENGLISH
Menu hierarchy & Setting Explanation
Detailed
explanation
Available Setting
options (range)
Unit Default
SERVICE
Runtimes
Compressor (Total runtime)
The total runtimes are of main components
re displayed.
The information can be used to identify
cause of excessive energy consumption or
abnormal cycling of compressor.
-h-
Compressor starts ---
Compressor (Heat mode) -h-
Compressor (Cool mode) -h-
Compressor (DHW mode) -h-
Compressor (Defrosting) -h-
Backup heater (Step 1) -h-
Backup heater (Step 2) -h-
Boost heater -h-
Main pump -h-
Solar pump -h-
Runtimes reset
Comp. Reset
In this menu, runtimes can be reset.
Reset - -
Backup heater Reset Reset - -
Boost Heater Reset Reset - -
Pump operation time Reset - -
Solar pump Reset Reset - -
CONNECTIVITY
Dry contact
Dry Contact Mode
- Manual: Unit must be turned-on by
Remote controller after release
by Dry contact
- Auto: Unit will automatically start (return
to previous operation) after release
by Dry contact
Auto / Manual - Auto
CN_CC
- D/C Automatic : Unit will recognize
connected Dry contact
after power-on
- D/C Not Installed: Dry contact is not
installed
- D/C Installed: Dry contact is installed and
unit always checks its state
Additionally, check setting
for 'Dry contact mode'!
- D/C Automatic
- D/C Not Installed
- D/C Installed
-
D/C
Automatic
To Next Page
Loading...
Need help?
General