LG MultiSITE MS8000 Series - Page 75

75
User Manual
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. “LG Life’s Good” is a registered trademark of LG Corp.
SERVICE VIEW SCREENS
MS8650 Service View Screen 3 / 9
MS8650 Service View Screen 3 / 9
Figure 60: MS8650 Service View Screen 3 / 9.
For MS8650 Only
Service View MS8650 Screen 3 / 9 Parameter Details.
Conguration Parameters Default Value Signicance and Adjustments
UI16 Binary (Universal Input Configuration
No. 1)
Read Only
Shows status of input.
Display Readings: Activated or Not Activated
UI17 Binary (Universal Input Configuration
No. 2)
Read Only
Shows status of input.
Display Readings: Activated or Not Activated
UI19 Analog (Universal Input Configuration
No. 3)
Read Only
Shows scaled percentage level of wired CO
2
sensor.
0% = 0ppm, 100% = 2000ppm
Display Readings: 0-100%
Airflow Level
Read Only
Shows the amount of air (in cubic feet/minute) that flows through a particular device.
Display Readings: 0-100%
Zigb. PIR Inst. (ZigBee Passive Infrared
Sensor Installed)
Read Only
Shows if ZigBee motion sensor is paired to a Controller or not.
This parameter is for ZigBee Motion Sensors only.
Display Readings: Off or On
Zigb. Sens. Mot. (ZigBee Sensor Motion)
Read Only
Shows if motion is detected by any of the wireless ZigBee motion sensors.
This parameter is for ZigBee Motion Sensors only.
Display Readings: Motion or No Motion
The Zigb. PIR Inst. and Zigb. Sens. Mot. are only for models
with the ZigBee PRO communication module.
* Zigb. PIR Inst.
* Zigb. Sens. Mot.
3/9 Service View
UI16 binary
Airflow level
UI19 analog
UI17 binary
0 CFM
0 %
Zigb. sens. mot.
Zigb. PIR inst.
No motion
Off
Not activ.
Not activ.