LG PREMTBB01 - Installer Setting - Thermistor

64
INSTALLATION INSTRUCTION
ENGLISH
INSTALLATION INSTRUCTION
65
ENGLISH
Installer Setting – Thermistor
This function is to select a temperature sensor to determine the indoor temperature.
Press and hold
B
button for more than 3 seconds to enter the installer settings mode.
- If pressing only once briefly, it will enter the user settings mode.
Make sure to press and hold for more than 3 seconds.
Move to the Selection of Indoor Temperature Sensor (Thermistor)
in the menu using
B
button and then, it displays as below.
Select the location of indoor temperature
sensor (Thermistor) using
FG
button.
Press
K
button to save the setting.
Press
L
button to exit.
 If no button is selected for about 25 seconds after setup, it exits the setup mode automatically.
 If Set button is not selected before you exit, the changes will not apply.
Code value for
Room temperature sensor
(Thermistor)
Set value
❈ Set value for sensor location
01 : Remote control
02 : Indoor unit
03 : 2TH
Temperature sensor
selection location
Function
01 Remote control Operating by a temperature sensor in Remote controller
02 Indoor unit Operating by a temperature sensor in the indoor unit
03 2TH
Cooling
Operating at a higher temperature after comparing the temperatures
between indoor unit and cable remote control
(Some product may operate at a lower temperature.)
Heating
Operating at a lower temperature after comparing the temperatures
between indoor unit and cable remote control
 2TH functions/features vary according to the product.
Set the ESP value using
FG
button.
Select a fan speed again using
FG
button, and set the ESP value for each speed.
Press
K
button to save the setting.
Press
L
button to exit.
 If no button is selected for about 25 seconds after setup, it exits the setup mode automatically.
 If Set button is not selected before you exit, the changes will not apply.
(The ESP value can be set from 1 up to 255,
and 1 is the smallest value and 255 is the largest value.)
Ex) 120 set for Breeze
Ex) 230 set for High
(ESP value for Breeze : 120)
(ESP value for High : 230)
• Pay special attention not to mix the ESP values for each speed.
• Some product may not allow you to program for Breeze and Power speed.
• The programmable ESP value may vary according to the product and capacity.
• When a power failure compensation is completed after power is on (at least 1 minute),
Please set or check the ESP value.
ENGLISH