LG PREMTBB01 - Installer Setting - Indoor Unit Auto-Start Setting; Installer Setting - Occupancy Duration Time Setting

86
INSTALLATION INSTRUCTION
ENGLISH
INSTALLATION INSTRUCTION
87
ENGLISH
Installer Setting – Occupancy Duration Time Setting
It is a function that sets the occupancy duration after motion is detected when installing an occu-
pancy sensor.
Select the code value and set value for each function using
FG
button.
Press and hold
B
button for more than 3 seconds to enter the installer settings mode.
- If pressing only once briefly, it will enter the user settings mode.
Make sure to press and hold for more than 3 seconds.
Press
B
button repeatedly to move to the Settings for Occupancy Duration Time in the menu as
below.
Press
K
button to save the setting.
Press
L
button to exit.
 If no button is selected for about 25 seconds after setup, it exits the setup mode automatically.
 If Set button is not selected before you exit, the changes will not apply.
Code value Set value
value time setting
00 0 minute
01 10 minutes
02 30 minutes
03 60 minutes
 Set value
Installer Setting – Indoor unit Auto-Start setting
It is a function that sets whether to restore the indoor unit operation by resuming the previous
power-on state or as power-off state in the power failure compensation.
Select the code value and set value for each function using
FG
button.
Press and hold
B
button for more than 3 seconds to enter the installer settings mode.
- If pressing only once briefly, it will enter the user settings mode.
Make sure to press and hold for more than 3 seconds.
Press
B
button repeatedly to move to the Settings for Indoor unit Auto-Start setting in the menu as
below.
Press
K
button to save the setting.
Press
L
button to exit.
 If no button is selected for about 25 seconds after setup, it exits the setup mode automatically.
 If Set button is not selected before you exit, the changes will not apply.
Code value Set value
❈ Set value
00 : Use indoor unit auto restart
01 : Not use indoor unit auto restart
ENGLISH