Liebert S600 - Page 55

Vertiv|Liebert® S600 10kVA ~ 20kVA UPS | User Manual 55
Alarm
Explanation
utility transition
Manual power-on
Set power-on via LCD panel
Manual shutdown
Set shutdown via LCD panel
Operating on
inverter
The UPS output state is on inverter
Battery series set
to 12 (12~20)
The battery cells changed (10kVA)
Battery series set
to 24 (24~40)
The battery cells changed (20kVA)
Restore factory
defaults
Under UPS stadby state, set 'Restore Factory Defaults' function via the Miantain
page
Output phase No.
set to 1
The output phase is changed from 3-phase to 1-phase
Output phase No.
set to 3
The output phase is changed from 1-phase to 3-phase
UPS is out of
service
The UPS is out of service
Turn on
programmable
outlet
The programmable outlet status is changed from Turn Off to Turn On
Turn off
programmable
outlet
The programmable outlet status is changed from Turn On to Turn Off
System parallel
settings start
sync
Manually set the 'Sync parallel paremters' command to activate the event
Local settings
sync OK
Local parameters are successfully synchronized
System settings
sync OK
All the parameters are successfully synchronized
Load off due to
output short
The inverter short circuit or the bypass short circiut. Please check it
Output off due to
overload &
bypass abnormal
The output is off due to output overload and bypass abnormal. Please check it