Lighthouse HANDHELD 2016, 3016, 5016 Gen F Operating Manual
4-2
248083400-1 Rev 7
10. When the HANDHELD starts counting, “COUNTING” appears
on the display. Particle counts are displayed according to the size
of each particle.
Note:
The pump motor
requires a minimum of 5
seconds to ramp up to full
flow. Refer to “Pump
Startup” on page 35.
11. If the instrument is in AUTO mode with cycles and a hold time,
“HOLDING” will display after each cycle and “FINISHED” will
display when all the cycles are complete.
12. Press the “STOP” button to stop the instrument before the cycles
are complete.
Touch Screen
Overview
The HANDHELD incorporates a unique touch screen interface to
control and configure the instrument.
This interface allows the user to easily view and configure the
instrument to specific needs and applications. See Figure 4-1.
Menu Map
Figure 4-1 Menu Map
To Next Page
Loading...
