Operation
248083400-1 Rev 7
4-35
Pump Startup
This is ON by default and sets a three-second pump ramp up time at the
beginning of the first sample, or at the beginning of all samples if the
HOLD time is greater than one minute, to stabilize the laser and air
flow. This setting should be left in the default mode unless special
applications, such as “surface scans”, require it to be disabled.
LANGUAGE
Pressing the LANGUAGE button allows the user to change the
operating language displaying the screen shown in Figure 4-44.
Figure 4-44 Operating Language Selection Screen
Press the desired language button then BACK or MAIN. The default is
English.
To Next Page
Loading...
