EasyManua.ls Logo

Lightmed LightLas 532 - System Software Is Ready to Shutdown

Lightmed LightLas 532
115 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
LightLas 532 Operator's Manual Rev. No 01 Page 32 of 115
performing Endo photocoagulation procedures, a sterile surgical site should be used
to reduce the risk of infection. European National Requirements may apply in some
EU countries and are to be observed by those users (Refer to Section 9 of this
manual).
The patient cannot have any influence over the operation and control of the New
LightLas 532 Laser System. Depending on the type of surgery being performed, the
delivery unit being used, and the condition of the patient, the doctor must decide on
the modality of the Laser use and whether or not an assistant is required during the
surgery.
As the laser system is designed to deliver the laser beam to heat the tissue, care must
be taken to avoid dangerous situations that could cause a fire or an explosion. The
Laser should never be fired in the direction of flammable gases or liquids which may
be present in the operating room.
Figure 4.3 System software is ready to shutdown
LCD Power
On / Off
Button

Table of Contents

Other manuals for Lightmed LightLas 532

Related product manuals