LightLas 532 – Operator's Manual Rev. No 01 Page 52 of 115
6. If the user needs to move the Laser system to a new location it is recommended
to lock all the movement screws on the Slitlamp and carefully transport to the
new location. If the new location is at a different facility then the User should
consider repackaging the Slitlamp Delivery system in its original foam packing
prior to moving to the new site. This will help to prevent any damage occurring
to the System. When the relocation is completed then the correct operation and
functioning of the Laser system should be performed according to the following
steps in this section and sections 7.2 and 7.3 of this Operator Manual.
7. The LightLas 532 Laser Console can be relocated easily as it is a portable device.
When required to be used with the LIO or Endo-ocular Probes the Console can be
carefully transported to the new surgery location. Treat the Laser Console with
the same care as should be offered to any precision surgical device. When the
Laser is set up at the new site check the operation as per Section 5.0 of this
manual.
8. When installing the LightLas 532 as a System with Slitlamp onto a Table then care
must be taken to ensure that the set-up is optimized for the User with all parts of
the System correctly installed and mounted so that both the Patient and Doctor
are comfortable and safe during the treatment. There are no specific safety
issues when installing the System however it is recommended that the
Motorized Table mains Power cable not be plugged into the same Multiple
Portable Socket Outlet as the Laser Console and Slitlamp power supply cables.
Use a separate wall mounted Power outlet.
5.2 Unpacking and Receiving Inspection
When receiving the laser system, there will usually be two cardboard boxes. One will
contain the laser console. Depending on what was ordered, the other may contain
the integrated system, AD delivery attachment kit, or the laser indirect
ophthalmoscope. Refer to figures 5.1 and 5.2 for examples.
Figure 5.1
Packing Carton for Integrated LDU and Slitlamp (Optional)
Top Layer: Protection Layer
Middle Layer: Upper Arm / Lower
Base Housings / Chinrest / Zoom pc
/ SD Magnifier/ Accessories
Bottom Layer: Table Top Assy
To Next Page
Loading...
