LightLas 532 – Operator's Manual Rev. No 01 Page 9 of 115
Section 1 INTRODUCTION
This manual is intended to provide the operator with an overview of the operation
and safety requirements for the LightLas 532 Ophthalmic Laser. This manual is not
intended to provide instructions on actual treatment procedures and it is expected
that users will have undertaken training prior to using the equipment.
The Manufacturer and Distribution organization assume no liability through the use
of this Laser system.
All care has been taken in the preparation and checking of this manual however there
is no guarantee provided that all information is correct. The information provided in
this manual is subject to change without notice.
Only approved or authorized accessories may be used in the LightLas 532. The
Manufacturer and Distribution organization shall not be held liable or responsible for
damages or injury caused as a result of using non-approved accessories. This includes
all Optical Fiber systems, Laser Delivery Units, Safety Filters, Safety Glasses and Table
units.
All maintenance and service work must be carried out by authorized and trained
service agents and only those procedures outlined in the operator and service
manual are allowed. Any service work carried out by unauthorized persons will void
all warranties.
No circuit diagrams or component part lists are to be supplied for the LightLas 532. If
you require technical documentation that is not provided in this manual then please
contact the manufacturer or your local distributor in writing with your reasons for
wanting them and then a copy of the service manual may be provided.
Before using the LightLas 532 Photocoagulator Laser system the operator should
read this manual carefully and pay particular attention to the sections of Safety,
Operation and Maintenance.
To Next Page
Loading...
