Lightmed LightLas 532 - Page 84

LightLas 532 – Operator's Manual Rev. No 01 Page 84 of 115
Installation Record Sheet
Model: LightLas 532
Console Serial Number: _________________
LIO Serial Number: _____________
Slitlamp LDU Serial Number: ______________
Safety Filter Serial Number: _______________
1. System Setup ( Tick for OK )
1.1 All parts received and checked OK. 
1.2 No damage to instrument packaging. 
1.3 Assemble Slitlamp Delivery Unit to Laser Console. 
1.4 Adjust cables then attach cable clamps etc. 
1.5 Plug in cables to Laser Console. 
1.6 Attach mains power cable. 
1.7 Attach Chinrest to Slitlamp if not yet fitted. 
1.8 Finish System assembly. 
2. Slitlamp Checks
2.1 Illumination Lamp Controls OK. 
2.2 4 filter wheel settings check OK. 
2.3 With Slit fully open 5 Aperture settings OK. 
2.4 With Large Aperture Set, Slit fully open get full circular spot. 
2.5 Slit is fully adjustable to closed position. 
2.6 When slit is closed there is no Illumination showing. 
2.7 Set narrow slit and check slit rotation + 90
o
around vertical. 
2.8 Load the target rod and set up the correct individual's ocular. 
2.9 Check that eyepieces fit firmly into binoculars and can be fully adjusted. 
2.10 Binoculars can be adjusted for interpupillary distance (PD). 
2.11 Check Slitlamp movements with joystick:
Vertical adjustment range OK. 
Sideways adjustment range OK. 
Forward adjustment range OK. 
Movements should be smooth. 
2.12 Illumination Tower and Binocular arm can be swung
from side to side OK. 
2.13 The replacement Illumination Tower is fitted to the Zeiss SL130 
(If applicable).