Linde E25 - Steering Cylinder and Track Rod Link

Service Training
Section 2.4
Page 4
2.4.1.2 STEERING CYLINDER AND TRACK ROD LINK
- Dismantle the steering axle.
- Remove the banjo bolts (11) along with the O-rings (12).
- Disconnect the two hydraulic hoses (10) at the steering cylinder (1).
- Drive out the roll pin (2) at the top and press the pin (3) out of the steering knuckle arm (15) to the track
rod link.
- Put the steering in the straight-ahead position.
NOTE: When pressing out the pin (3), support the underside of the steering knuckle arm (15) to prevent
it from being damaged.
- Remove the track rod link (5) along with the bearings (6) and sealing rings (4) from the steering knuckle
arm (15).
- Unscrew the sensor nut and remove the sensor.
- Mark the position of the two bearing brackets (8) in relation to the axle body (9).
NOTE: The two bearing brackets must not be interchanged during re-assembly.
- Unscrew the fastening screws (7) for the bearing brackets (8) and remove the bearing brackets.
- Remove the steering cylinder (1) and track rod links.
- Drive the roll pin (13) out the pin (14) on the steering cylinder at the track rod end and press the pin out.
- Remove the track rod link.