Linde E25 - Installing the Steering Cylinder and Track Rod Link

Service Training
Section 2.4
Page 12
2.4.1.6 INSTALLING THE STEERING CYLINDER AND TRACK ROD LINK
- Insert the track rod links (5) into the steering cylinder (1).
- Coat the pin (14) with MoS
2
grease and press it in (pressing force 5 - 50 kN).
- Secure the pin (14) with a roll pin (13).
- Place the steering cylinder along with the track rod links on the centre axle (9).
- Install the marked bearing brackets (8) correctly and fasten them with screws (7) (torque to 425 Nm).
- Coat the pin (3) with MoS
2
grease and press it into the track rod link (5) and steering knuckle arm with the
roller pin pointing up (pressing force 4 - 38 kN).
NOTE: When pressing in pin (3), support the steering knuckle arm from below to prevent any damage
to it.
- Secure pin (3) with a roll pin (2).
- Install the hydraulic hoses (10) along with the banjo screws (11) and O-rings (12) on the steering cylinder
(1).