5 Maintenance
Inspection and maintenance overview
6000 h service plan
At operating hours
Carried
out
6000 12000
9
8
Information on service plan
Dependent on the consumables used, the driving style and the operating conditions,
but at least every three years. Refer also to the recommendation for consumables.
Preparations
Clean the truck if necessary
Read out error memory and delete
Calibrate the drive potentiometer and joysticks
Enter the next maintenance interval
Engine
Renew the engine oil
Change the engine oil filters
Drain the fuel fi
lter
Check condition and secure positioning of engine support and engine mount
Change V-ribbed belt
Change toothed belt and tensioning pulley (at latest after 5 years)
Clean water cooler and hydraulic oil cooler
Check coola
nt concentration
Change air filter cartridge, check vacuum-operated switch
Change the safety cartridge in the air filter
Change the breather filter for charge air regulation
Clean th
eoilbathairfilter
Check i
ntake and exhaust pipes for leaks
Check the particle filter system
Clean the pressure control device at the changing particle filter
Clean the water trap at the changing particle filter
Gear
box
Axle clamps and wheel motors: check the mountings
Drive axle: check the side stops
Drive axle: check bearing for wear
114 Operating Instructions – 394 807 10 01 EN – 07/2011
To Next Page
Loading...
