5 Maintenance
Engine
¾ Release the cap (1) from the engine oil filter
(2) with a 32 AF open-ended spanner and
unscrew by hand.
¾ Collect oil that escapes from the oil filter
and dispose of it and the oil filter in an
environmentally friendly manner.
¾ Insert new oil filter insert.
¾ Replace O-ring of cap.
¾ Screw on cap by hand until O-ring is seated.
¾ Tighten to 25 Nm.
¾ Close the bonnet.
NOTE
After changing the oil and the filter, carry out
an engine test run, checking the oil pressure
indicator and the tightness of the oil drain plug
and oil filter. For an accurate oil level check,
especially after changing the oil filter, it is
necessary to switch off the engine again and
then carry out an oil level check after approx.
one minute.
Fuel
Check the fuel level
ENVIRONMENT NOTE
Observe information regarding working with
consumables.
¾ Switch on the ignition.
124 Operating Instructions – 394 807 10 01 EN – 07/2011
To Next Page
Loading...
