4 Operation
Standard equipment
¾ Take your feet off the accelerator pedals
(3).
¾ Turn the switch key (2) to the zero position.
NOTE
The brake is applied when the engine is
switched off.
¾ Turn the parking brake lever (1) in a clock-
wise direction until it engages.
The parking brake is now ap
plied.
¾ Remove the switch key (2) when leaving the
truck.
Driving (dual-pe
dal operation)
WARNING
It is generally not permitted to drive on long gra-
dients over 15% due to specified minimum braking
and stability values. Please contact your authori-
sed dealer before driving on larger gradients. The
climbing capability values given in the type sheet
have been determined from the pulling force and
only apply when overcoming obstacles on the road-
way and for small height differences.
You should always adapt your driving to the conditi-
ons of the route used (unevenness etc.), especially
hazardous work areas and your load.
WARNING
When using mirrors, remember that the rear-view
mirror is only designed for monitoring the area
behind the vehicle.
Reverse travel is therefore only permitted when
looking directly behind you.
CAUTION
Any side doors attached must be protected from
damage when driving.
Please therefore ensure that both side doors are
closed and locked before setting off.
46 Operating Instructions – 394 807 10 01 EN – 07/2011
To Next Page
Loading...
