Operation 4
Standard equipment
NOTE
Sitting for long periods of tim
e puts a lot of
pressure on the spine. Try to co
mpensate for
this by performing regular sim
ple gymnastic
movements.
Longitudinal adjustment
¾ Pull lever (1) upwards.
¾ Move the driver’s seat backwards or for-
wards on the runners to find the most com-
fortable position for the driver in relation to
the steering wheel and the accelerator ped-
als.
¾ Allow lever (1) to snap in
to place.
Adjusting the seat back
rest
¾ Push lever (2) upwards and hold in place.
¾ Move the seat backrest forwards or back-
wards until a comfortable seating position
for the driver is found.
¾ Release lever (2).
Setting the driver’s
weight
NOTE
The individual driver’s weight must be set
when the driver’s seat is under load.
¾ Check the weight setting in the inspection
window (4).
The correct driver’s weight has been set
when the arrow is in the centre position in
the inspection window (4).
Adjust the driver’s weight as necessary.
¾ Pull out the lever (3).
Move the lever to set the driver’s weight for the
suspension.
¾ Move the lever (3) upwards for a heavier
weight.
¾ Move the lever (3) downwards for a lighter
weight.
Operating Instructions – 394 807 10 01 EN – 07/2011 33
To Next Page
Loading...
