Operating manual and inspection booklet
Camping
144 3435216
Service menu
Calibrating the heating room sensor (OFFSET)
Fig. 139: Presetting: 0 °C (Celsius)
The room temperature sensor of the connected heating can be
adjusted individually at the sensor installation location. Setting is
possible in steps of 0.5 °C in the range 0 °C to -5 °C.
Example:
Set room temperature 23 °C, OFFSET = -1 °C;
-Heating target value = 22 °C
Fault
Fig. 140: Fault
In the event of a fault the Truma CP plus control panel
immediately jumps to the “Fault” menu level. The cause of the
fault can be determined and rectified with the aid of the
troubleshooting guides.
E = Fault
112 = Error code
H = Device
H = Heating
A = Air conditioning system
NOTICE
Contact a specialist workshop!
To Next Page
Loading...