Lord MicroStrain WSDA-2000 - Multi-Port Connector Interface

WSDA
®
-2000 User Manual
9.2 Multi-port Connector Interface
The WSDA-2000 multi-port connector is currently only used for CAN J1939 output connections and
customized RS232 options, such as for use with LORD Sensing inertial sensors. The remaining are
used during manufacturing, or are reserved for future use. For mating connector information and pre-
made cable assemblies see Ethernet Gateway Accessories on page 1 .
Pin
Number
Signal
Pin
Number
Signal
1
(future use)
14
(future use)
2
(reserved)
15
+5V
3
+5V
16
(future use)
4
(reserved)
17
Tx
5
GND
18
+5V
6
(future use)
19
Rx
7
(future use)
20
GND
8
(not used)
21
1 PPS Out
9
(future use)
22
1 PPS In
10
GND
23
CAN High
11
(future use)
24
CAN Low
12
(future use)
25
(future use)
13
+5V
26
(future use)
Table 12 - Multi-port Pin Designations
71