Basic System Setup4
4.4 STEP 4: Connect monitor
OR
CAUTION
The system will automatically match the resolution of the connected monitor the first time you use the recorder. If
you need to switch monitors, make sure you set the recorder to an output resolution supported by the new monitor
BEFORE switching. See 15.5.1 Setting the Recorder’s Output Resolution, page 58 for details.
4.5 STEP 5: Connect power
Use the included power adapter to connect the recorder to a nearby outlet. Turn the recorder on us-
ing the power switch on the back panel.
4.6 STEP 6: Lorex Setup Wizard
When you first power up your recorder, the Lorex Setup Wizard will begin. The Wizard will help
you configure core system settings and set up your cameras. It is recommended to review , page
before choosing a permanent mounting position for your cameras.
NOTE
For detailed mounting instructions for your particular camera model, refer to your camera’s documentation on
lorex.com.
#LX400111; r. 5.0/56647/56647; en-US 8
To Next Page
Loading...
Need help?
General
