Display Modes
16
EN
The unit will automatically begin loading when power is
connected to the DVR, and the ON/OFF button on the
back of the unit is switched to ON.
1. The DVR will perform a Firmware check.
During the loading sequence, the following
information will be displayed:
• 4 or 8 Channel DVR and Firmware
Version
• Video Type: NTSC or PAL
• Disk0 Check: Displays information
about the connected Hard Drive
• Read Info: Checks previously recorded
data
• Disk1 Check: Displays information
about a second hard drive (not
available in this model).
• CD-Drive: Displays information about
the connected CD/DVD Drive.
2. The unit will initially load to a split screen view,
displaying all 4 or 8 cameras (depending on
model) with Camera Names and Recording
Status. The Drive Full, Date and Time are
displayed in the bottom bar. If a camera cannot
be displayed, a Video Loss Icon appears, and
the channel will display a blank blue screen
instead of an image.
Display Modes
Initial Loading Sequence
1
8CH STANDALONE DVR LOREX
(FW:2.50.85 UCODE:86)
VIDEO: NTSC
DISK0: 78533MB HD7280PLAT20
READ REC INFO … DONE
DISK 1: NONE
CD DRIVE: HL-ST DVD-RAM 1.07
[STOP] TO STOP
2
2007/10/10 01:02:03
V-LOSS
NOTE: If a new HARD DRIVE is detected, the
system will prompt you to FORMAT the drive. If
you do not choose to format the HARD DRIVE, the
drive will not be detected by the system.
If you choose to FORMAT a drive in this way, the
drive will no longer be readable by a regular PC.
Press the PLAY button to format the drive, or pres
the STOP button to cancel the format.
8CH STANDALONE DVR LOREX
(FW:2.50.85 UCODE:86)
VIDEO: NTSC
DISK0: 78533MB HD7280PLAT20
NEW DISK
DISK1: NONE
DISK0: PRESS [PLAY] FORMAT
[STOP] CANCEL
FORMAT … DONE.
CD DRIVE: HL-ST DVD-RAM 1.07
x
CH1 CH2
CH3 CH4
100%4 1007/01/01 01:02:03
To Next Page
Loading...
Need help?
General