System Setup Controls
28
EN
BUZZER ALARM TIME
LOSS ALARM
AUDIO RECORD
AUDIO MUTE
AUDIO INPUT VOL.
AUDIO OUTPUT VOL.
PASSWORD SETUP
TIME SETUP
SYSTEM MENU
>
PASSWORD ENABLE
The Password Enable feature turns the use of
a system password ON or OFF. If the option is
set to YES, the password is required when
entering the Setup Menu, Resetting Factory
Defaults, Using the PTZ and Stopping video
recording.
TIME SET SUBMENU
The Time Set menu controls the date and time
for the DVR.
• TIME ZONE – Set the current time
zone by scrolling through available
options (GMT based timezones).
• TIME SET – Use the arrows to adjust
the Date and Time (YYYY/MM/DD
HH:MM:SS). Press the Menu/Exit
button to finish changing the settings.
• APPLY – Select the Apply option and
press the ENTER button to save the
changes to the date and time.
• SYNC. FROM NTP SERVER –
Synchronizes the system with a
Network Time Server (over the
Internet ) to set the date and time. An
internet connection is required.
• NTP SERVER IP – Enter the IP
address of the Time Server. The
default value time server IP is
203.117.180.36.
SYSTEM EVENT LIST SUBMENU
The Event List provides a detailed listing of the
events that have occurred in the system.
The Event List includes:
• DVR Power ON / OFF
• Recording Start / Stop
• Sensor ON / OFF
• Motion Detection
• Timed Recording Start / Stop
The list is displayed by Event Number, Date,
Time and Event type.
Navigate through the events using the arrow
buttons.
To Playback a valid event, select the event
from the list and press the ENTER button.
To Next Page
Loading...
Need help?
General